Yukon/Denali 4WD V8-6.0L VIN U (2004)
5. Install the J22536 as shown.
Ensure that the J22536 is firmly seated on the pinion.
6. Drive the pinion out using the J 22536 and a hammer.
Strike the J 22536 slowly. Do not let the pinion fall out of the rear axle housing.
7. Remove the pinion preload shims from the drive pinion and set aside.
8. Remove the inner pinion bearing and the pinion position shim.
Important: The ring gear bolts have right-hand threads.
9. Remove the ring gear bolts. Discard the bolts.
Notice: Refer to Ring Gear Removal Notice in Service Precautions.
10. Remove the ring gear from the differential case. Drive the gear off with a brass drift if necessary.
Installation Procedure
