Yukon/Denali 4WD V8-6.0L VIN U (2004)
2. If equipped with the double clamp style boot, perform the following steps to install the propeller shaft to the transfer case:
2.1.
Install a new clamp in the groove of the propeller shaft boot.
2.2.
Install the propeller shaft splines in the transfer case output shaft.
3. If equipped with the single clamp style boot, install the propeller shaft splices into the transfer case output shaft.
4. Install the propeller shaft (5) to the front axle pinion yoke (1).
Align the reference marks made during removal.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the yoke retainers (7) and the bolts (6).
^
Tighten the yoke retainer bolts to 25 Nm (18 ft. lbs.).
6. For both style of boots, install the boot onto the transfer case output shaft until the boot snaps into the groove on the output shaft.
7. If equipped with the double clamp style boot, use the J 43218 to crimp the clamp until the dimensions shown are obtained.
