Yukon/Denali 4WD V8-6.0L VIN U (2004)
Notice: Refer to Fastener Notice in Service Precautions.
5. Insert a drift or a large screwdriver through the brake caliper into 1 of the brake rotor vanes in order to prevent the wheel drive shaft from turning.
^
Tighten the inboard flange bolts to 79 Nm (58 ft. lbs.).
^
Tighten the hub nut to 240 Nm (177 ft. lbs.).
6. Remove the drift from the rotor.
7. Install the drive axle center cap, if equipped.
8. Install the stabilizer shaft link. Refer to Stabilizer Shaft Replacement in Front Suspension.
9. Install the wheel and tire assembly. Refer to Tire and Wheel Removal and Installation.
10. Lower the vehicle.
