Yukon/Denali 4WD V8-6.0L VIN U (2004)
20. Pull on the CV joint (4) to verify engagement.
21. Slide the large diameter of the CV joint boot (1), with the large swage ring (2) in place, over the outside edge of the CV joint outer race (4).
22. Clamp the CV joint boot (2) tightly to the CV joint outer race (1) with the large swage ring (4), using the following procedure:
23. Mount the base of J 36652 in a vise.
24. Position the CV joint end (outboard end) of the halfshaft assembly in the bottom half of J 36652.
25. Align the following during this procedure:
^
The CV joint boot (3)
^
The CV joint assembly (1)
^
The swage ring (2)
26. Install the top half of J 36652 onto the lower half of the tool, over the CV joint boot (3) and the CV joint assembly (1).
27. Align the swage ring (2) and the swage ring clamp.
28. Insert the bolts into J 36652.
^
Hand tighten the bolts until the bolts are snug.
^
Tighten each bolt 180 degrees at a time. Alternate between the bolts until both sides of the top half of J 36652 touch the bottom half of the
tool.
29. Loosen the bolts and remove the halfshaft assembly from J 36652.
