Yukon/Denali 4WD V8-6.0L VIN U (2004)
Case: Service and Repair
Transfer Case - BW 4481-NR3
Transfer Case Shield Replacement
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting in Service Precautions.
2. Remove the transfer case shield bolts, if equipped.
3. Remove the transfer case shield, if equipped.
Installation Procedure
1. Position the transfer case shield, if equipped.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the transfer case shield bolts, if equipped.
^
Tighten the bolts to 20 Nm (15 ft. lbs.).
3. Lower the vehicle.
