Yukon/Denali XL 1500 2WD V8-6.0L VIN U (2005)
9. Remove the park brake actuator lever housing from the backing plate.
10. Remove the backing plate.
Installation Procedure
1. Install the park brake actuator lever housing to the backing plate.
2. Install the park brake shoe.
3. Install the wheel bearing and adjust the park brake shoe. Refer to Wheel Hub and Bearing Replacement in Rear Wheel Steering and Park Brake
Adjustment in Park Brake.
4. Install the park brake cable to the park brake actuator lever.
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the rear park brake bracket bolt.
Tighten the bolt to 61 Nm (45 ft. lbs.).
