Yukon/Denali XL 1500 2WD V8-6.0L VIN U (2005)
4. Route the cable in through the floor pan and engage the grommet.
5. Remove the safety stands.
6. Lower the vehicle.
7. Roll the carpet into place.
8. Install the park brake pedal. Refer to Park Brake Pedal Assembly Replacement.
9. Adjust the park brake system. Refer to Park Brake Adjustment.
(Without RPO Nys)
Park Brake Cable Replacement - Left Rear (without RPO NYS)
Removal Procedure
1. Ensure that the park brake is released.
2. Raise and support the vehicle.
3. If vehicle is a 1500 series with the first design cable, perform the following:
1. Relieve tension on the park brake cables by pulling down on the front park brake cable (1) just in front of the equalizer.
2. Remove the left rear park brake cable (3) from the equalizer bar.
3. Remove the park brake cable from the frame bracket and guides.
