Yukon/Denali XL 1500 4WD V8-5.3L VIN T (2004)
Important:
^
If the encoder motor is being replaced, ensure that the transfer case is in the neutral position. Manually shift the transfer case at the shift shaft,
using a crescent wrench if necessary.
^
When installing the encoder motor, ensure that the encoder motor is indexed correctly and the motor is flat against the transfer case before
tightening the bolts.
1. Apply a 3.175 mm (1/8 inch) bead of sealant, GM P/N 12345739, (Canadian P/N 10953541), or equivalent to the sealing surface of the encoder
motor.
2. Install the encoder motor.
Rotate the shift detent lever to align to the encoder motor.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install encoder motor bolts.
^
Tighten the bolts to 10 Nm (89 inch lbs.).
4. Connect the encoder motor electrical connector (2).
5. Install the front propeller shaft.
6. Install the transfer case shield, if equipped.
