Yukon/Denali XL 1500 4WD V8-6.0L VIN U (2004)
1. Insert new clamps (3) into the original halfshaft seal cover (1) (if you are reusing the original halfshaft seal cover.
2. Slide the halfshaft seal cover (1) onto the halfshaft assembly (2), starting at the outboard (CV joint) end.
3. Align the inboard clamp (2) on the inboard joint (1). Align the seal cover seam so the seam is straight.
Important: Tighten the seal cover clamp (1) as tight as possible without deforming the retaining clip. Clamps that are not tight enough allow the
cover to slide upon the joint. This causes shortened service life.
4. Use J 41187 in order to tighten the inboard seal cover clamp (1).
