Yukon 2WD V8-393 6.5L DSL Turbo VIN S (1995)
Brake Warning Indicator: Initial Inspection and Diagnostic Overview
Circuit Operation
Battery voltage is applied through the GAUGES FUSE 4 to the "BRAKE" Indicator when the Ignition Switch is in the RUN, BULB TEST or START
positions. The "BRAKE" Indicator can be lit by having ground applied to it from any of three switches or the Antilock Brake Module.
The "BRAKE" Indicator will light whenever the parking brake is engaged. When the parking brake is engaged, ground is supplied through the closed
contacts of the Parking Brake Warning Switch to the "BRAKE" Indicator. The "BRAKE" Indicator lights to alert the driver that the parking brake is
engaged.
The "BRAKE" Indicator will light when the Ignition Switch is turned from the "LOCK" to the RUN position. This is when the Antilock Brake Module
conducts its initial test which entails lighting the "BRAKE" Indicator and the ABS Indicator. The Antilock Brake Module will also light the "BRAKE"
Indicator if there is a malfunction within the Four Wheel Antilock Brake System which is affecting the operation of the base hydraulic braking system.
The "BRAKE" Indicator will light if there is low brake fluid pressure in he front or rear brakes. When the Combination Valve senses low brake fluid
pressure in the front or rear brakes it closes the Brake Pressure Warning Switch. A ground is supplied through the closed contacts of the Brake Pressure
Warning Switch to the "BRAKE" Indicator With both power and ground applied to the "BRAKE" Indicator, it will light.
If the vehicle is equipped with Daytime Running Lamps (DRL), then there is an ignition Switch BULB TEST function that will light the "BRAKE"
Indicator whenever the Ignition Switch is turned to the BULB TEST position.
Troubleshooting Hints
1. Check condition of GAUGES Fuse 4. If fuse is Open, locate and repair source of overload. Replace fuse.
2. Check that G105 is clean and tight.
3. Check the "BRAKE" Indicator bulb for an open filament.
4. Check that the parking brake is fully released.
5. Make sure that there is an adequate amount of brake fluid in the reservoir.
^
Check for a broken (or partially broken) with inside of the insulation which could cause system malfunction but prove "GOOD" in a
continuity/voltage check with a system disconnected. These circuits may be intermittent or resistive when loaded, and if possible, should be
checked by monitoring for a voltage drop with the system operational (under load). Check for proper installation of aftermarket electronic
equipment which may affect the integrity of other systems (Refer "Troubleshooting Procedures"). See: Diagrams/Diagnostic Aids
