Yukon 2WD V8-393 6.5L DSL Turbo VIN S (1995)
Blower Motor Resistor: Service and Repair
Without Air Conditioning
Main Unit (Front)
Blower Motor Resistor
REMOVE OR DISCONNECT
1. Negative battery cable.
2. Roll instrument panel back.
3. Plenum tray.
4. Electrical connector.
5. Screws.
6. Resistor.
INSTALL OR CONNECT
NOTE: When installing resistor to the heater case, do not let the resistor coils contact each other. Improper system operation or vehicle damage could
result.
1. Resistor.
2. Tighten Screws to 1.9 Nm (17 lb in).
3. Electrical connector.
4. Plenum tray.
5. Roll instrument panel forward.
6. Negative battery cable.
-
Check circuit operation.
Rear Unit (Auxiliary)
