Yukon 2WD V8-393 6.5L DSL Turbo VIN S (1995)
Seals and Gaskets: Service and Repair
Full-Floating Axle 11 Inch Ring Gear
^
Tool Required:
-
J 8614-01 Pinion Flange Holder and Remover
-
J 24384 Pinion Oil Seal Installer (Dana 11 inch ring gear axle).
^
The pinion oil seal and the pinion flange may be replaced with the carrier assembly installed in the vehicle.
REMOVE OR DISCONNECT
^
Raise the vehicle.
1. Propeller shaft.
Important: Scribe a line on the pinion stem, pinion nut and pinion flange to be used as an installation guide.
2. Nut using J 8614-01.
3. Flange using J 8614-01.
4. Oil seal.
-
Use the special nut and forcing screw to remove the flange.
-
Pry the oil seal from the bore. Do not damage the machined surfaces.
