Yukon 2WD V8-5.3L (2007)
Wheel Speed Sensor: Service and Repair
Rear Wheel Speed Sensor Replacement
Rear Wheel Speed Sensor Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Disconnect the electrical connector.
3. Remove the wheel speed sensor retaining bolt.
4. Release the wheel speed sensor wiring harness from the retainers.
5. Remove the wheel speed sensor.
Installation Procedure
1. Using a twisting motion, install the wheel speed sensor until fully seated.
Notice: Refer to Fastener Notice.
2. Install the wheel speed sensor retaining bolt.
Tighten the wheel speed sensor retaining bolt to 13 N.m (115 lb in).
3. Connect the electrical connector.
4. Install the wheel speed sensor wiring harness to the retainers.
5. Lower the vehicle.
6. Perform a low speed test to ensure the wheel speed sensor is functioning properly: