Yukon 2WD V8-5.3L (2007)
Harmonic Balancer - Crankshaft Pulley: Service and Repair
Crankshaft Balancer Replacement
Tools Required
^
J 41478 Crankshaft Front Oil Seal Installer
^
J 41665 Crankshaft Balancer and Sprocket Installer
^
J 41816-A Crankshaft Balancer Remover
^
J 41816-2 Crankshaft End Protector
^
J 42386-A Flywheel Holding Tool
^
J 45059 Angle Meter
Removal Procedure
1. Remove the air conditioning (A/C) drive belt. Refer to Drive Belt Replacement - Air Conditioning.
2. Remove the cooling fan and shroud.
3. Remove the starter motor.
Notice: Refer to Fastener Notice.
Important: Ensure that the teeth of the J 42386-A mesh with the teeth of the engine flywheel.
4. Install the J 42386-A (1) and bolts. Use one M10-1.5 x 120 mm and one M10-1.5 x 45 mm bolt for proper tool operation.
Tighten the J 42386-A bolts to 50 N.m (37 lb ft).
