Yukon 2WD V8-5.3L (2007)
5. Apply threadlock to the threads of the ignition coil bracket studs. Refer to Sealers, Adhesives, and Lubricants.
6. Position the ignition coil bracket (719) onto the rocker cover.
7. Install the ignition coil bracket studs (720).
Tighten the studs to 12 N.m (106 lb in).
8. Install the spark plug wires (724) to the ignition coils.
9. Position the engine harness, as necessary.
10. Install the engine harness clip (4) to the ignition coil bracket stud.
11. Connect the engine harness electrical connector (1) to the ignition coil wire harness.
12. Install the CPA retainer (2).
13. Install the intake manifold cover. Refer to Upper Intake Manifold Sight Shield Replacement.
