Yukon 2WD V8-5.3L (2007)
Notice: Refer to Fastener Notice.
2. Working through the wheelhouse opening, install the engine mount to engine bolts (1).
Tighten the bolts to 50 N.m (37 lb ft).
3. Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
4. Remove the adjustable jack from the engine block.
5. Install the engine mount to frame bolts (1).
Tighten the bolts to 65 N.m (48 lb ft) starting with the middle bolt then either side bolt.
6. Install the A/C compressor bracket.
7. If the vehicle is equipped with 4WD, Install the front drive axle bracket and bolts.
Tighten the bolts to 90 N.m (67 lb ft).
