Yukon 2WD V8-5.3L (2007)
Tighten the bolt to 100 N.m (74 lb ft).
7. For 1500 series vehicles, raise the differential carrier into position.
8. Install the differential carrier right side nuts.
9. Install the differential carrier left side bolts.
Tighten the bolts/nuts to 100 N.m (74 lb ft).
10. If equipped, install the engine protection shield. Refer to Engine Shield Replacement.
11. Remove the jack or utility stand from the rear of the vehicle.
12. Lower the vehicle.
Important:
^
Ensure the oil cooler line being installed has a plastic cap on the end that connects to the quick connect fitting. If no plastic cap
exists, or the plastic cap is damaged, obtain a new cap. Install the cap onto the cooler line prior cooler line installation.
