Yukon 2WD V8-5.3L (2007)
1. If replacing the catalytic converter assembly, perform the following steps, otherwise proceed to step 4.
2. If reinstalling the old sensors, coat the threads with anti-seize compound GM P/N 12377953, or equivalent.
Notice: Replacement components must be the correct part number for the application. Components requiring the use of the thread locking
compound, lubricants, corrosion inhibitors, or sealants are identified in the service procedure. Some replacement components may come with these
coatings already applied. Do not use these coatings on components unless specified. These coatings can affect the final torque, which may affect
the operation of the component. Use the correct torque specification when installing components in order to avoid damage.
Notice: Refer to Fastener Notice.
3. Install the HO2S's (2 and 3) to the catalytic converter assembly.
Tighten the sensors to 42 N.m (31 lb ft).
4. Install the NEW exhaust seal (1) as required.
5. Slide the catalytic converter hanger (3) into the hanger bracket.
