Yukon 2WD V8-5.3L (2007)
9. Remove the steering knuckle.
Installation Procedure
1. Clean all grease and contaminants from the tapered section and the threads of the upper ball joint, the lower ball joint, and the tie rod end.
2. Clean and inspect the taper holes and the mounting surfaces of the steering knuckle. If any of the tapered holes are elongated, out of round, or
damaged, replace the steering knuckle.
3. Install the steering knuckle.
Notice: Refer to Fastener Notice.
4. Connect the lower ball joint to the steering knuckle and install the retaining nut.
Tighten the nut to 110 N.m (81 lb ft).
5. Connect the upper ball joint to the steering knuckle and install the retaining nut.
Tighten the nut to 50 N.m (37 lb ft).
6. Install the brake hose and the bracket retaining bolt to the steering knuckle
Tighten the bolt to 9 N.m (80 lb in).
7. Connect the outer tie rod to the steering knuckle.
8. Install the wheel hub and bearing assembly.
9. Install the tire and wheel.
10. Remove the lower control arm support.
11. Lower the vehicle.
12. Verify the wheel alignment. Refer to Wheel Alignment Specifications.
