Yukon 2WD V8-5.3L (2007)
3. Install the upper control arm retaining bolt to the frame bracket.
Notice: Refer to Fastener Notice.
Important: Do not tighten the nuts unless the suspension is at the curb height position.
4. Install the upper control arm retaining nut.
Tighten the upper control arm retaining bolts to 160 N.m (118 lb ft).
5. Connect the ESC sensor, if equipped.
6. Lower the vehicle.
Rear Axle Lower Control Arm Replacement
Rear Axle Lower Control Arm Replacement
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the lower control arm retaining nuts.
3. Remove the lower control arm retaining bolt.
4. Remove the lower control arm.
Installation Procedure
