Yukon 2WD V8-5.3L (2007)
Torsion Bar: Service and Repair
Torsion Bar Replacement (2500 Series)
Tools Required
J 36202 Torsion Bar Unloading/Loading Tool
Removal Procedure
Notice: Use care when handling the torsion bars in order to avoid chipping or scratching the coating. Damage to the coating will result in
premature failure of the torsion bars.
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Install the J 36202 to the adjustment arm and the crossmember.
3. Increase the tension on the adjustment arm until the load is removed from the adjustment bolt and the adjuster nut.
Important: Mark the adjustment bolt and count the number of times that is required to remove the adjustment bolt.
4. Remove the adjustment bolt (3) and the adjuster nut (4).
5. Remove the adjustment bolt (3) and the adjuster nut (4).
6. Remove the J 36202, allowing the torsion bar to unload.
