Yukon 2WD V8-5.3L (2007)
1. Install J 25025-5 into the valve body bolt hole where the manual shaft detent roller and spring is mounted.
2. Install the valve body gasket (2) onto the accumulator housing (1).
3. Install the valve body spacer plate (3) onto the valve body gasket (2).
4. Install the third and fourth clutch accumulator housing gasket (3).
5. Install the third clutch accumulator piston spring (1). This spring is the longer of the 2 springs.
6. Install the fourth clutch accumulator piston spring (4).
7. Install the third and fourth clutch accumulator housing assembly (5) onto the control valve body assembly (2).
8. Install the 6 accumulator housing bolts (6). Start the bolts finger tight and work towards the opposite end.
Notice: Refer to Fastener Notice.
9. Tighten the accumulator housing bolts (1-6) sequentially.
Tighten the bolts to 11 N.m (97 lb in).
10. Remove the J 25025-5.
11. Install the valve body.
Important: It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the engine control module (ECM),
powertrain control module (PCM) or transmission control module (TCM) will need to relearn TAP values. Transmission performance
may be affected as new TAP values are learned.
12. Reset the TAP values. Refer to Transmission Adaptive Functions.
