Yukon 2WD V8-5.3L (2007)
Tighten the bolts to 11 N.m (97 lb in).
15. Remove J 25025-5.
16. Install the manual shaft detent roller and spring (3) and bolts.
17. Install the 2 wiring harness clips (1) and bolts (2).
18. Install the wiring harness clip (1) and bolts (2).
19. Install the lube oil pipe (5) with the short end into the valve body.
20. Install the lube oil pipe retainer (7) and the bolt (6).
21. Install the valve body bolts and tighten in the order shown.
Tighten the bolts to 11 N.m (97 lb in).
22. Install the remaining valve body bolts.
Tighten the bolts to 11 N.m (97 lb in).
23. Connect the internal wiring harness to the valve body electrical components.
24. Install the transmission filter.
Important: It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, the engine control module (ECM),
powertrain control module (PCM), or transmission control module (TCM) will need to relearn TAP values. Transmission performance
may be affected as new TAP values are learned.
25. Reset the TAP values. Refer to Transmission Adaptive Functions.
