Yukon 2WD V8-5.3L VIN T (2006)
Fog/Driving Lamp Switch: Service and Repair
Fog Lamp Switch Replacement - Rear
FOG LAMP SWITCH REPLACEMENT - REAR
REMOVAL PROCEDURE
1. Remove the instrument panel bezel.
2. Pull out the accessary switch housing.
3. Disconnect the electrical connectors.
4. Remove the fog lamp switch from the accessary switch housing.
INSTALLATION PROCEDURE
1. Install the fog lamp switch into accessary switch housing.
2. Connect the electrical connectors.
3. Install the accessary switch housing.
4. Install the instrument panel bezel.
