gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

Tire Pressure Module > < Tire Pressure Monitor - TPM System Message/Service Tips|Page 3304
Page 2
background image

low tire warning light will begin to flash. The double horn chirp and flashing TPMS warning light indicate that the TPMS matching process has
started. The TPMS warning light should continue flashing throughout the matching procedure. The "SERVICE TIRE MONITOR" message will
be displayed on the Driver Information Center (DIC).

4. Start with the driver's side front tire.
5. Remove the valve cap from the valve cap stem. Activate the TPMS sensor by increasing or decreasing the tire's air pressure for 10 seconds, then

stop and listen for a single horn chirp. The single horn chirp should sound within 15 seconds, confirming that the sensor identification code has
been matched to this tire and wheel position. If you do not hear the confirming single horn chirp, you will need to start over with Step 1. To let
air-pressure out of a tire you can use the pointed end of the valve cap, a pencil-style air pressure gage or a key.

6. Proceed to the passenger's side front tire, and repeat the procedure in Step 5.
7. Proceed to the passenger's side rear tire, and repeat the procedure in Step 5.
8. Proceed to the driver's side rear tire, and repeat the procedure in Step 5.
9. After hearing the confirming horn chirp for the left rear tire, check to see if the TPMS warning light is still flashing. If it is, turn the ignition switch

to LOCK to exit the sensor matching process. If the TPMS warning light is not flashing, the five minute time limit has passed and you will need to
start the process over beginning with Step 1.

10. Set all four tires to the recommended air pressure level as indicated on the Tire and Loading Information label.
11. Put the valve caps back on the valve stems.

The spare tire does not have a TPMS sensor. If you replace one of the road tires with the spare, the "CHECK TIRE PRESSURE" message will be
displayed on the DIC screen. This message should go off once you re-install the road tire containing the TPMS sensor. The "SERVICE TIRE
MONITOR" message is displayed when the TPMS is malfunctioning. One or more missing or inoperable TPMS sensors will cause the service tire
monitor message to be displayed.

Tire Pressure Module > < Tire Pressure Monitor - TPM System Message/Service Tips|Page 3304