Yukon 2WD V8-5.3L VIN T (2006)
7. Align the hole in the pinion shaft with the bolt hole in the differential case.
8. Notice: Refer to Fastener Notice in Service Precautions.
Install the new pinion shaft locking bolt.
^
For the 8.6 inch axle, tighten the pinion shaft locking bolt to 36 Nm (27 ft. lbs.).
^
For the 9.5/9.5LD inch axle, tighten the pinion shaft locking bolt to 50 Nm (37 ft. lbs.).
9. Install the rear cover and the gasket.
10. Install the brake caliper.
11. Install the tire and wheel assembly.
12. Fill the rear axle. Use the proper fluid. Refer to Capacities - Approximate Fluid and Fluid and Lubricant Recommendations.
13. Lower the vehicle.
