Yukon 4WD V8-5.3L (2008)
8. Remove the brake hose to caliper bolt.
Important: Ensure the washers are not still attached to the brake hose or the brake caliper.
9. Remove and discard the 2 copper brake hose gaskets.
10. Remove the brake hose from the brake caliper.
Important:
*
DO NOT use any air tools to remove or install the brake caliper bolts. Use hand tools ONLY.
*
Install an open end wrench to hold the caliper guide pin in line with the brake caliper while removing or installing the brake caliper
bolt. DO NOT allow the open end wrench to come in contact with the brake caliper. Allowing the open end wrench to come in contact
with the brake caliper will cause a pulsation when the brakes are applied.
11. Using an open end wrench to hold the guide pin, loosen the brake caliper bolts.
12. Remove the brake caliper bolts.
