Yukon 4WD V8-5.3L (2008)
Door Module: Customer Interest
Tire Monitor System - Tire Pressure Light Stays ON
TECHNICAL
Bulletin No.: 08-03-16-004A
Date: January 29, 2009
Subject:
Tire Pressure Light Stays On (Reprogram RCDLR)
Models:
2008-2009 Buick Lucerne
2008-2009 Cadillac CTS, DTS, Escalade, Escalade ESV, Escalade EXT
2008-2009 Chevrolet Avalanche, Silverado, Suburban, Tahoe
2008-2009 GMC Sierra, Sierra Denali, Yukon, Yukon Denali, Yukon XL, Yukon Denali XL
2008-2009 HUMMER H2
2009 Saturn VUE
with Vehicle Build Dates Between January 1, 2008 and August 15, 2008
Supercede:
This bulletin is being revised to add the Avalanche and 2009 Saturn VUE to the models. Please discard Corporate Bulletin Number 08-03-16-004
(Section 03 - Suspension).
Condition
Some customers may comment that the tire pressure light stays on even though tire pressure values are correct. It should also be noted that no DIC
messages have been displayed and a scan tool will reveal no DTCs within the RCDLR.
Correction
Important:
From the controller list, select RCDLR Remote Control Door Lock Receiver (Pass-Thru Only).
If all the above conditions have been met, then reprogram the RCDLR. A revised service calibration has been released to address this issue. Reprogram
the RCDLR using the TIS2WEB Service Programming System (SPS) application. As always, make sure your Tech 2(R) is updated with the latest
software version.
Important:
The Copy and Paste TPM Information function in Tech 2(R) must be used when reprogramming the RCDLR. This function can be used to copy all
the information that is related to the tire pressure monitoring system (including tire sensor ID's) and paste the information into a freshly SPS
reprogrammed RCDLR. Refer to Remote Control Door Lock Receiver Programming and Setup in SI for additional information.
Warranty Information
Disclaimer