Yukon 4WD V8-5.3L (2008)
8. Remove the knuckle from the vehicle.
Installation Procedure
1. Install the knuckle on the lower ball joint. Refer to Lower Control Arm Replacement (1500) ()Lower Control Arm Replacement (2500) (See:
Suspension/Control Arm/Service and Repair/Front Suspension/Lower Control Arm Replacement (2500)) .
2. Install the upper ball joint in the knuckle. Refer to Upper Control Arm Replacement (2500) (See: Suspension/Control Arm/Service and
Repair/Front Suspension/Upper Control Arm Replacement (2500))Upper Control Arm Replacement (1500) () .
3. Install the outer tie rod end. Refer to Steering Linkage Outer Tie Rod Replacement (See: Tie Rod/Service and Repair/Steering Linkage Outer Tie
Rod Replacement) .
4. Install the wheel bearing and hub assembly. Refer to Front Wheel Hub, Bearing, and Seal Replacement (1500) ()Front Wheel Hub, Bearing, and
Seal Replacement (2500) (See: Suspension/Wheel Hub/Service and Repair) .
5. Install the wheel drive shaft, if equipped. Refer to Wheel Drive Shaft Replacement (2500) (See: Transmission and Drivetrain/Drive Axles,
Bearings and Joints/Axle Shaft Assembly/Service and Repair)Wheel Drive Shaft Replacement (1500) () .
6. Remove the support from the lower control arm.
7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair) .