Yukon 4WD V8-5.3L (2008)
5. Install the power steering pump fitting seal (3) to the power steering pump assembly (1).
Notice: Refer to Fastener Notice .
Important: Start the power steering fluid reservoir studs and the power steering pump flow control valve fitting by hand before
finalizing any torques.
6. Install the power steering pump fitting (4) to the power steering pump assembly (1).
Tighten the fitting to 75 N.m (55 lb ft).
7. Install the power steering fluid reservoir studs (2) to the power steering pump assembly (1).
Tighten the studs to 58 N.m (44 lb ft).
8. Install the power steering pump assembly to the vehicle. Refer to Power Steering Pump Replacement (4.8L, 5.3L, 6.0L, and 6.2L) (See: Power
Steering Pump/Service and Repair) .
