Yukon 4WD V8-5.3L (2008)
Band Apply Servo: Service and Repair
2-4 Servo
Tools Required
J 29714-A Servo Cover Depressor
Removal Procedure
1. Remove the catalytic converter pipe. Refer to Catalytic Converter Replacement (1500 Series) Catalytic Converter Replacement (LFA) .
2. Remove the heat shield bolts.
3. Remove the heat shield.
4. Support the transmission.
5. Remove the transmission crossmember. Refer to Transmission Support Crossmember Replacement (4WD 2500 series) Transmission Support
Crossmember Replacement (2WD 1500 series) Transmission Support Crossmember Replacement (2WD 2500 series) Transmission Support
Crossmember Replacement (4WD 1500 series) .
6. Lower the transmission with a suitable jack.
7. Remove the oil pan bolt below the servo.
8. Install the J 29714-A .
9. Tighten the bolt on J 29714-A in order to compress the servo cover.
10. Remove the servo cover ring.
11. Remove the J 29714-A .
