Yukon 4WD V8-5.3L (2008)
1. Install the J 43484 (2) to the J 8092 (1).
2. Install a NEW seal onto J 43484 .
3. Using J 43484 (2), and J 8092 (1), install the seal.
4. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement (See: Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller
Shaft/Service and Repair/Front Propeller Shaft Replacement) .
5. Check the fluid level. Add fluid, if necessary.
6. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement (See: Service and Repair/Removal and Replacement/BW
4485-NR3 - Transfer Case/Transfer Case Shield Replacement) .
7. Lower the vehicle.
Rear Output Shaft Seal Replacement
Rear Output Shaft Seal Replacement
Tools Required
J 45756 Output Shaft Seal Installer
Removal Procedure
