Yukon 4WD V8-6.5L DSL Turbo VIN S (1997)
Brake Light Switch: Service and Repair
Stoplamp Switch
Remove or Disconnect
1. Negative battery cable.
2. Disable SIR. Refer to Air Bags and Seat Belts.
3. Retainer from brake pedal pin. Use snap ring pliers.
4. Switch by unsnapping from pushrod.
5. Electrical connector from switch.
Install or Connect
1. Electrical connector into switch.
2. Switch by snapping it into pushrod.
3. Retainer onto brake pedal pin. Use 11 mm (7/16 inch) socket to push new clip on pin.
4. Negative battery cable.
5. Enable SIR. Refer to Air Bags and Seat Belts.
