Yukon 4WD V8-6.5L DSL Turbo VIN S (1997)
Turbo Boost Sensor: Service and Repair
Boost Sensor
WARNING: Failure to disconnect the negative battery terminal may result in personal injury or damage to the vehicle's components. Turn
OFF the vehicle ignition, unless instructed otherwise.
REMOVE OR DISCONNECT
Disconnect the negative battery cable under the following circumstances:
-
When installing an electrical unit.
-
When a tool or equipment could easily come into contact with "live"exposed electrical terminals.
1. Negative battery cable.
2. Electrical Connector.
3. Mounting Bolts.
4. Remove the sensor.
INSTALL OR CONNECT
1. Install the port gasket on the sensor.
2. Install the sensor
3. Install mounting bolts.
Tighten
-
Bolts 3.5 Nm (27 lb. in.).
4. Install the electrical connector.
5. Connect the negative battery cable.
