Yukon 4WD V8-6.5L DSL Turbo VIN S (1997)
Tool For Removing Center Support Bearing
Tool For Removing Center Support Bearing (Side View)
Tool For Removing Center Support Bearing (Installation View)
Install or Connect
^
New bearing (32) to the driveshaft (31), using a locally fabricated tool (open tube) that bears on the bearing inner race only. Press on the
bearing until the inner race bottoms out against the shoulder on the driveshaft.
Drive End Housing Bushing
If necessary, replace the bushing (37) in the drive housing (39).
