Yukon 4WD V8-6.5L DSL Turbo VIN S (1997)
5. New nuts (170 and 165).
^
Tighten
-
Tighten front nut prior to tightening rear nut.
-
Nuts (170 and 165) to 165 Nm (121 ft. lbs.).
-
The nuts must be tightened with the control arm at the specified "Z" height.
-
Prelube the steering knuckle seal.
-
Start the drive axle through the hub.
6. Ball joint (115) to the knuckle (117).
7. Ball joint nut (131). Tighten to 128 Nm (94 ft. lbs.).
8. Cotter Pin.
-
Flatten the cotter pin against the sides of the nut.
9. Adjuster arm (186).
-
Slide the bar rearward to install the sides of the nut.
-
Load the torsion bar, using J 36202.
-
Install the adjuster bolt and screw it down to the installation mark.
10. Outer axle shaft washer (119) and nut (120) to the hub assembly (114). Tighten (120) to 225 Nm (165 ft. lbs.).
11. Lower shock bolt.
12. Stabilizer link.
13. Tire and wheel assembly.
