Yukon 4WD V8-6.5L DSL Turbo VIN S (1997)
Constant Velocity Joint: Service and Repair
Remove and Reinstall Tripot Joint and Seal
Remove Drive Axle Seal Cover (Optional)
^
Required Tools:
-
J 8059 Snap Ring Pliers
-
J 35910 Seal Clamp Tool
1. Use a side cutters in order to cut the drive axle seal cover clamps and the nylon strap.
Important: If the drive axle seal cover will be reused, do not damage the drive axle seal cover while removing the clamps.
2. Slide the drive axle seal cover off of the drive axle, over the CV joint end.
3. Check the drive axle seal cover for rips, tears, worn spots or other damage. Reuse the drive axle seal cover if there is no damage visible.
Disassemble Tripot Joint and Seal
^
Required Tools:
-
J 8059 Snap Ring Pliers
1. Use a hand grinder in order to cut through the swage ring. Do not damage the tripot housing.
2. Remove the tripot housing from the drive axle. Wipe the grease off of the tripot assembly roller bearings and the tripot housing. Thoroughly
