Yukon 4WD V8-6.5L DSL Turbo VIN S (1997)
^
Screws to 7 Nm (62 Lbs. in.).
3. Drive link brackets to the wiper motor crank arm. Assemble the brackets in the order shown in Figure 20. (Right side linkage closest to the wiper
motor).
^
Drive link nuts to 5 Nm (44 Lbs. in.).
4. Electrical connector to the wiper motor.
5. Cowl vent grille.
6. Wiper arm assemblies.
^
Place the wiper arms on the transmission drive shafts and lock them into place with the latch.
7. Negative battery cable.
Circuit Board and Terminal Assembly Replacement
REMOVE OR DISCONNECT
1. Negative battery cable.
2. Wiper motor electrical connector.
3. Cover screws.
4. Cover.
5. Circuit board and terminal assembly by lifting up on terminal.
INSTALL OR CONNECT
1. Circuit board and terminal assembly.
2. Cover and three screws.
Tighten
^
Screws to 2.6 Nm (23 lbs. in.).
3. Wiper motor electrical connector.
4. Negative battery cable.
