Yukon Denali 2WD V8-6.0L Hybrid (2010)
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Heated Seats Description and Operation (KA1) (See: Description and Operation/Heated Seats Description and Operation (KA1))Heated Seats
Description and Operation (KA6) (See: Description and Operation/Heated Seats Description and Operation (KA6))
Electrical Information Reference
*
Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
*
Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Connector
Repairs/Connector Repairs)
*
Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
*
Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information
Circuit/System Verification
1. Ignition ON, observe the appropriate scan tool Seat 1 or 2 HVC Data parameters listed below while pressing and releasing the appropriate switch.
The readings should change from Off to Back and Cushion or Back Only.
*
Driver Seat HVC Mode
*
Passenger Seat HVC Mode
‹› If not the specified values and there are no DTCs set, replace the HVAC control module.
2. If all scan tool parameters test normal and there are no DTCs set, replace the MSM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Diagnostic Trouble
Code Tests and Associated Procedures/Verification Tests and Procedures) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning)for memory seat module and HVAC control module
replacement, programming, and setup
