Yukon Denali 2WD V8-6.0L Hybrid (2010)
-
The illustration above shows the latches in the tumble position.
3. If the latches are in the tumble position, place the seat in an upright position on a firm surface. With the back folded down, pull up on the tumble
lever while pushing down on the seat to reset the front floor latches.
4. If the front floor latches are in the correct position and the condition still exists, visually inspect the front floor latch roller bar for a twist or out of
sync condition.
-
The bar is straight in the above illustration.
-
The bar is twisted in the above illustration.
5. If the front floor latches appear to be twisted or out of sync, replace the roller bar. Do not replace the complete latch assembly.
6. To replace the roller bar, remove the two Torx bolts and remove the roller bar.
7. Install the new roller bar and tighten the bolts.
Tighten
Tighten the two Torx bolts to 16 Nm (12 lb ft).
