Yukon Denali 2WD V8-6.0L Hybrid (2010)
1. Install 2 large C-clamps over the top of the caliper housing and against the back of the outboard brake pad.
2. Slowly tighten the C-clamps until the caliper pistons are pushed completely into the caliper bores.
3. Remove the C-clamps from the caliper.
7. Clean all dirt and debris from the brake caliper and fittings.
Note: Cap or plug to the brake hose to prevent brake fluid leakage and contamination of the brake system.
8. Remove the brake hose to caliper bolt.
9. Remove the brake hose from the caliper.
Note:
*
Ensure that the copper gaskets are not attached to the brake caliper or the brake hose.
*
DO NOT re-use the copper gaskets, replace them with NEW.
10. Remove and discard the 2 copper brake hose gaskets.
11. Remove the brake caliper guide pin bolts from the brake caliper.
12. Remove the brake caliper from the mounting bracket.
Installation Procedure
1. Install the brake caliper to the mounting bracket.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
