Yukon Denali 2WD V8-6.0L Hybrid (2010)
1. Install NEW brake pad retaining springs to the caliper bracket.
2. Install the brake pads to the caliper bracket.
3. Install the caliper to the caliper bracket.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the brake caliper bolts and tighten to 108 Nm (80 lb ft).
5. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
6. Lower the vehicle.
7. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
8. Slowly release the brake pedal.
9. Wait 15 seconds, then repeat steps 7-8 until a firm pedal is obtained, to properly seat the brake caliper pistons and brake pads.
10. Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary. Refer to Master Cylinder Reservoir Filling (See:
Hydraulic System/Brake Master Cylinder/Service and Repair/Procedures/Master Cylinder Reservoir Filling).
11. Burnish the pads and rotors. Refer to Brake Pad and Rotor Burnishing (See: Procedures).
