Yukon Denali 2WD V8-6.0L Hybrid (2010)
5. Install the caliper to the caliper bracket. Refer to Front Brake Caliper Replacement (2500 Series) (See: Front Brake Caliper Replacement (2500
Series))Front Brake Caliper Replacement (1500 Series) (See: Front Brake Caliper Replacement (1500 Series)).
6. Slowly apply pressure to the brake pedal until a firm pedal is achieved.
7. Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary. Refer to Master Cylinder Reservoir Filling (See: Brake
Master Cylinder/Service and Repair/Procedures/Master Cylinder Reservoir Filling).
8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
Rear Brake Caliper Hardware Replacement (2500 Series)
Rear Brake Caliper Hardware Replacement (2500 Series)
Warning: Refer to Brake Dust Warning (See: Service Precautions/Technician Safety Information/Brake Dust Warning).
Removal Procedure
1. Inspect the fluid level in the brake master cylinder reservoir.
2. If the fluid level is midway between the maximum - full point, and the minimum allowable level, no fluid needs to be removed from the reservoir
before proceeding.
3. If the fluid level is higher than midway between the maximum - full point, and the minimum allowable level, remove fluid to the midway point
before proceeding.
4. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair
).
5. Compress the brake caliper pistons.
1. Install a large C-clamp over the body of the top of the caliper housing and against the back of the outboard pad.
2. Slowly tighten the C-clamp until the pistons are pushed completely into the caliper bores.
3. Remove the C-clamp from the caliper.
