Yukon Denali 2WD V8-6.0L Hybrid (2010)
4. Install the park brake cable to the track bar and secure in place with the clips. Verify the clips are installed between the locators on the track bar
(1500 series).
5. Position the park brake cable to the cable guides on the vehicle frame.
6. Install the park brake cable to the mounting bracket until the tabs lock into place.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
7. Install the bolt to the rear axle cable clip (2500 series) and tighten to 22 Nm (16 lb ft).
Note: After installing the cable to the rear axle holding clip, verify the clip is securely retaining the cable. If not, crimp the clip by hand taking
care not to pinch or kink the cable.
8. Install the cable to the differential clip (2500 series).
