Yukon Denali 2WD V8-6.0L Hybrid (2010)
Note: The sight shield mounting fastener must be installed and tightened. Failure to properly tighten the sight shield mounting fastener may result
in an open High Voltage Interlock Circuit (HVIC) condition and DTCs.
1. Install the sight shield onto the ball studs (2) and tighten the sight shield mounting fastener (1). Tighten the fastener to 5 Nm (44 lb in).
2. Install the fender brace. Refer to Front Fender Rear Upper Bracket Replacement (See: Body and Frame/Fender/Front Fender/Service and
Repair/Front Fender Rear Upper Bracket Replacement).
3. Enable high voltage. Refer to High Voltage Enabling (See: Battery System, Hybrid Drive/Testing and Inspection/Initial Inspection and
Diagnostic Overview/High Voltage Enabling).