Yukon Denali 2WD V8-6.0L Hybrid (2010)
Note: The gray side tabs on the accessory dc power control module (APM) assembly connector (2) must be pressed in before rotating the lever.
20. Disconnect the APM assembly connector (2) using the following procedure:
1. Push the green tab.
2. Squeeze the gray side tabs, then rotate the lever.
21. Disconnect the APM assembly connector (3) using the following procedure:
1. Remove the locking tab.
2. Insert a small flat blade screwdriver into the locking tab area and raise the tab while pulling on the connector.
22. Disconnect the remaining APM assembly connector (1).
23. Remove the sight shield circuit breaker fasteners (1).
24. Remove the sight shield circuit breaker (2).
