Yukon Denali 2WD V8-6.0L Hybrid (2010)
3. Install the power vacuum brake booster pushrod retainer (1).
4. Rotate the pushrod retainer 360 degrees to verify the retainer is fully engaged in the groove on the brake pedal pin.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
5. Install the power vacuum brake booster pushrod retainer bolt (1) and tighten to 10 Nm (89 lb in).
6. Connect the stoplamp switch electrical connector.
7. Install the driver knee bolster. Refer to Knee Bolster Replacement (Cadillac) (See: Body and Frame/Interior Moulding / Trim/Dashboard /
Instrument Panel/Service and Repair/Knee Bolster Replacement (Cadillac))Knee Bolster Replacement (Except Cadillac) (See: Body and
Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Service and Repair/Knee Bolster Replacement (Except Cadillac)).
