gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

Procedures|Page 1809 > < Procedures|Page 1807
Page 6
background image

2. Install the auxiliary A/C evaporator tubes (3) to the clamps (5).

Caution:  Refer to Fastener Caution   (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).

3. Install the heater/A/C tubes retaining nut (4) to the stud (1) at the frame (6) and tighten to 7 Nm (62 lb in).

4. Install the auxiliary A/C evaporator tubes (2, 3) and the retaining nut to the auxiliary HVAC module and tighten to 16 Nm (12 lb ft).
5. Lower the vehicle.
6. Install the rear wheelhouse liner. Refer to Rear Wheelhouse Panel Liner Replacement (RPO HP2)   (See: Body and Frame/Fender/Rear

Fender/Rear Fender Liner/Service and Repair/Rear Wheelhouse Panel Liner Replacement (RPO HP2))Rear Wheelhouse Panel Liner Replacement
(RPO X88 Chevrolet, RPO O88 GMC)   (See: Body and Frame/Fender/Rear Fender/Rear Fender Liner/Service and Repair/Rear Wheelhouse
Panel Liner Replacement (RPO X88 Chevrolet, RPO O88 GMC)).

7. Install the right assist step. Refer to Assist Step Replacement (Z71)   (See: Body and Frame/Auxiliary Step / Running Board/Service and

Repair/Assist Step Replacement (Z71))Assist Step Replacement (Power BRS)   (See: Body and Frame/Auxiliary Step / Running Board/Service
and Repair/Assist Step Replacement (Power BRS))Assist Step Replacement (Chevrolet HP2)   (See: Body and Frame/Auxiliary Step / Running
Board/Service and Repair/Assist Step Replacement (Chevrolet HP2))Assist Step Replacement (GMC Denali XL)   (See: Body and
Frame/Auxiliary Step / Running Board/Service and Repair/Assist Step Replacement (GMC Denali XL)).

8. Install the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Right Side   (See: Body and Frame/Fender/Front Fender/Front

Fender Liner/Service and Repair/Front Wheelhouse Liner Replacement - Right Side).

9. Install the auxiliary A/C evaporator tubes (3) to the condenser tube (2) and the accumulator (5) using the nuts and tighten to 16 Nm (12 lb ft).

10. Recharge the refrigerant to the system. Refer to Refrigerant Recovery and Recharging (HP2)   (See: Heating and Air Conditioning/Service and

Repair/Refrigerant Recovery and Recharging (HP2))Refrigerant Recovery and Recharging (Non-HP2)   (See: Fluids/Refrigerant/Service and
Repair).

11. Leak test the fittings of the component using the J 39400-A.

Procedures|Page 1809 > < Procedures|Page 1807