Yukon Denali 2WD V8-6.0L Hybrid (2010)
1. Mark the connectors to their corresponding injectors to ensure correct reassembly.
2. Pull the CPA retainer on the connector up 1 click.
3. Push the tab on the connector in.
4. Disconnect the fuel injector electrical connector.
14. Remove the engine wiring harness clip (4) from the ignition coil bracket stud.
Note: The auxiliary heater water pump hose and the surge tank outlet hose do not need to be removed from the bracket in order to reposition the
bracket.
15. Remove the heater hose bracket nut (2) and bracket (1). Reposition the bracket out of the way. Hoses shown removed for clarity.
16. Remove the engine wiring harness clip bolt (4).
17. Gather the branches of the engine wiring harness and reposition the aside.
