Yukon Denali 2WD V8-6.0L Hybrid (2010)
Installation Procedure
1. Install the CKP sensor.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the CKP sensor bolt.
Tighten the bolt to 25 Nm (18 lb ft).
3. Connect the engine wiring harness electrical connector (1) to the CKP sensor.
4. Position the engine wiring harness sleeve (2) over the CKP sensor electrical connection.
5. Lower the vehicle.
6. Perform the CKP system variation learn procedure. Refer to Crankshaft Position System Variation Learn (See: Testing and Inspection).
